BeamMonitor BM+
35,0(6
24
Revision 02/2019 EN
10.2
Connect the BeamMonitor BM+ with the LaserDiagnosticsSoftware LDS
10.2.1
Connect device
1. Switch on the BeamMonitor BM+.
The operating mode is shown in the
status display (see chapter 9 on page
2. Start the LaserDiagnosticsSoftware
LDS.
3. Click on the
Devices
tab.
4. Click on the
+
Connect to device
button under the tab.
The
Connections
window appears.
5. Click on the desired device.
6. Click on the
Connect to device
but-
ton.
10.2.2
Change the network address of a connected device
Proceed as follows in order to assign a dif-
ferent IP address to a connected device:
1. Right-click on the device and select
the
Device settings
menu point.
2. Enter in the desired IP address or
use the
Use DHCP
option and con-
firm the entry with
OK
.
3. Turn the BeamMonitor BM+ off and
on again.
