BeamMonitor BM+
35,0(6
26
Revision 02 EN - 02/2022
9.2.3
Change the network address of a connected device
For communication in a network, a
Static IP address
is stored for the device in the LDS and the function
Use DHCP
is activated. When establishing a connection, the device will first wait to be assigned a suitable IP
address via DHCP. If this proofs unsuccessful, it will revert to the static IP address.
If
Use DHCP
is disabled, the device will directly use the static IP address. As a result, the connection can be
established faster.
For a connected device, both the IP address and the activation of DHCP can be changed.
Change the IP address of a device as
follows:
1. Click on the
Devices
tab.
2. Right-click on the device and select
the
Device settings
menu point.
3. Enter the desired IP address or use
the
Use DHCP
function
4. Confirm the entry with
OK
.
5. Switch the device off and on again.
9.2.4
Disconnect and switch off the device
1. Click on the
Devices
tab.
2. Right-click on the device and select
the
Disconnect
menu point.
The device is no longer connected to
the LDS.
3. Switch off the device.
4. If necessary, disconnect the electrical
connections.
