BeamMonitor BM+
35,0(6
18
Revision 02 EN - 02/2022
7.3
Deinstallation of the device
1. Turn off the laser source.
2. Ensure that moving parts, e.g. robot arms, etc. are at a standstill and cannot be set in motion uninten-
tionally.
3. Switch off the BM+ at the Power On / Off switch.
4. Unscrew the fixing screws from the threaded holes.
5. Disconnect the cables and remove the device from the laser system.
8
Connections
Please only use the PRIMES power supply unit and the provided connection cables.
Please establish all electrical connections and switch on the device before starting the LaserDiagnosticsSoft-
ware LDS.
8.1
Overview of the connections
8.1.1
Connections of the BeamMonitor BM+ 60
Ethernet
PRIMES-Bus
RS485
Power supply
connection
Fig. 8.1:
Connections of the BeamMonitor BM+ 60
8.1.2
Connections of the BeamMonitor BM+ 100S
Ethernet
PRIMES-Bus
RS485
Power supply
connection
Fig. 8.2:
Connections of the BeamMonitor BM+ 100S
