PRIMERGY BX620 S3, User Manual

Page: 206 / 287

206
Chapter 8 Hardware Configuration/Utilities
8.1 Switch Block Settings
This section explains how to set the switch block.
8.1.1 Switch block
This section explains how to set the switch block (
b
in "1.3.3 Baseboard" (pg.28)) on the baseboard.
The following table shows the description of each switch.
• When setting the switch block, be sure to turn the server blade off, and then
remove the server blade from the chassis. Failure to do so may cause electric
shock.
For details on how to remove the server blade from the chassis, refer to
"BX600 S2 Blade Server System Unit Hardware Guide".
table: Switch Block Settings
Switch No. Description
Switch 1 Sets whether or not to delete a password.
• ON: Deletes the password.
• OFF: Does not delete the password. (Default)
Switch 2 Sets whether or not to clear the information stored on the CMOS.
• ON: Clears the information stored on the CMOS.
• OFF: Maintains the information stored on the CMOS. (Default)
Switch 3 Always keep in OFF position.
Switch 4 Always keep in OFF position.
Switch 5 Always keep in ON position.
Switch 6 Always keep in ON position.
OFF
ON
3 4 1 2 5 6