Making Network and SAN Connections
Release 5.0
5-17
Configuring the cBlades to Join a Network
This section describes how to configure the BladeFrame BF200 to
join a network. This section covers the following topics:
•
Modifying External Management IP Addresses
•
Modifying Internal Management IP Addresses
•
Modifying Host Names
Modifying
External
Management IP
Addresses
A conflict with a default
external
management IP address arises if
the same address already exists on your network. Use the
extnet
command to change the default address of the external interfaces on
the BladeFrame BF200 if a conflict exists. Table 5.2 shows the
default IP addresses.
When you make modifications to external IP addresses, make sure
the BladeFrame is not connected to your network.
To change the external management IP addresses:
1.
Connect your console to Control Blade 1.
2.
Log on as
root
.
Table 5.2 External Management IP Addresses
External Management Interface
IP Address
(Default Value)
PAN Manager
192.168.200.1
Control Blade 1
192.168.200.2
Control Blade 2
192.168.200.3
Summary of Contents for BladeFrame BF200
