BUILT-IN CERAMIC HOB
INSTALLATION AND OPERATION MANUAL
Please read the instruction manual carefully before operating your new hob.
PRCEH104
PRCEH106
Cod
：
0070303280
Dear Owner: Thank you for purchasing our cooktop which is designed to give you many years of
cooking pleasure. Before using your new appliance please read the user's manual carefully and keep it
in a safe place for future reference.
THIS APPLIANCE MUST BE INSTALLED ONLY BY A QUALIFIED PERSON IN INSTRUCTIONS
PROVIDED. THE MANUFACTURER DECLINE ALL RESPONSIBILITY FOR IMPROPER INSTALLA-
TION WHICH MAY HARM PERSONS AND ANIMALS OR CAUSE DAMAGE TO PROPERTY. THE
APPLIANCE MUST BE USED ONLY FOR THE PURPOSE FOR WHICH IT WAS EXPRESSLY
DESIGNED. ANY OTHER USE (e.g. HEATING ROOMS) IS CONSIDERED TO BE IMPROPER AND
MANUFACTURER DECLINES ALL RESPONSIBILITY FOR DAMAGE RESULTING FROM
IMPROPER AND IRRESPONSIBLE USE.
A duplicate data label and wiring diagram are contained in this booklet.Please attach these labels to an
accessible and near by surface for easy reference. The Manufacturer shall not be held responsible for
any innaccuracies in this handbook due to printing or transcription errors,also the designs in the figures
are purely indicative. The Manufacturer also reserves the right to make any modifications to the
products as may be considered necessary or useful also in the interests of the user, without
jeopardizing the main functional and safety features of the products themselves.
Use
Directions and suggestions for using
1.
Do not touch the built-in ceramic hob with wet hands or feet.
2.
Do not operate the built-in
ceramic
hob when you are barefoot.
3.
Do not let young children operate the built-in ceramic hob.
4.
Please disconnect the power supply before you do any maintenance and cleaning.
5.
When the built-in ceramic hob is working, the temperature of the hob and the ambien
t temperature
become higher, so please do not touch it and keep the children away from it.
6.
A steam cleaner must not be used for cleaning the appliance.
7.
The appliance is not intended to be operated by means of an external timer or separate
remote-control system.
8.
The built-in ceramic hob must be built into a heat resistant cabinet. Some smoking may occur when
first used. Leave on for a short period to burn off excess sealant.
Operation of the top with the heating area
An appropriately selected pan saves energy. A pan should have a thick, flat base with a diameter equal
to the plate diameter as in that case heat is transferred most efficiently.
Advice on the use of cooking tops. To save energy and to
prolong the
life of the ceramic tops, we
advise using pans with flat bottom and with a diameter no less than the diameter of the tops. Care must
be taken that fluids do not spill on the ceramic plates. Never leave the tops on without pans on them or
with empty pans and never use the tops to heat plates. Switch on the
elements
after having set the
pans on them. Once switched off, the
elements
remain warm for a while, do not touch. Switch off the
heating element before removing the pans.
• Select the cooking zone (fig. 2) and heat level (fig. 3).
•
Press the timer button (fig. 5), and then use the up and down buttons to set the countdown time.
• Each time the timer up
/
down button is pressed, the timer display will increase or
decrease in 1 minute increments.
Safety cut-off
• If one or more of the cooking zones are accidentally left on, a safety cut-off will activate
after a certain period of time. The length of time depends on the set power level for that
zone. The table on the right gives the time limits for each power level.
• If more than one zone is operating when one of the zones reaches its safety cut-off
point, only the zone that has reached its safety cut-off point will switch off.
fig.1
fig.2
fig.3
fig.4
fig.5
Touch control For PRCEH106
• All operations are performed by means of the touch controls on the control panel.
• Each touch control has a corresponding visual display (indicator light).
• You will hear a beep each time a touch is registered.
Switching on the ceramic hob
• Press the ON/OFF button (fig. 1) to switch on the appliance.
• The hob will beep once and all cooking zone indicators will light up briefly
, i
ndicating
that
the hob has entered stand-by mode .
Notice:
Take the next step within one minute, otherwise the controller will automatically
shut down.
Switching on a cooking zone and setting a power leve
l
• Press the cooking zone select button (fig. 2) for the zone you want to use.
• Select the heat level required (1-9) by using the up and down buttons (fig. 3). By holding
down either of these buttons, the value on the heat level display will adjust up or down.
Note:
when the power displayed 0, press the down button, the power will set to 9.
Switching off the ceramic hob
1. Press the ON/OFF button, the hob will switch off. It is possible to turn the hob off at any
time by pressing the ON/OFF button.
2. Press the up or down buttons to 0, then hob will switch off.
After a zone is switched off, the corresponding heat level display will show a flashing letter “H” .
This means that the temperature of the zone is above 60°C and is therefore still high enough
to cause injury.
•
When the temperature of the zone falls below 60°C the letter “H” will go out. It is still
possible to burn yourself on a hob zone, even when its temperature has dropped below 60°C.
IMPORTANT:
The residual heat indicator will disappear if the mains supply to the product is cut.
Locking the ceramic hob
To lock the ceramic hob, press the safety lock button (fig. 4) while the appliance is
switched on.
With the safety lock activated, all buttons on the control panel will be
disabled, except
the ON/OFF button. To disable the safety lock feature, press the safety
lock button again.
Y
ou are then able to adjust the heat level of any zone on the hob.
Timer
If
t
ouch
-c
ontrolled, your hob has a timer which you can set (from 1 to 99 minutes) for each
cooking zone. At the end of the countdown period, a buzzer will sound and the relevant
cooking zone will be switched off.
PRCEH106
SAFETY WARNING
1. Please check the built-in ceramic hob's integrity after opening the package. If
there are any problems please refer to the supplier.
2. Do not throw the package materials (plastic bag, foam, nails, package etc) in a
place where children can easily access. Please dispose of packaging in an
environmentally friendly manner.
3. Do not change the wiring under any circumstances.
4. Dispose of the appliance in an environmentally friendly manner.
5. If the supply cord is damaged,it must be replaced by the manufacturer its service
agent or similarly qualified persons in order to avoid a hazard.
6. Children and persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge should be supervised to ensure appliance is used
safely.
7. Children should be supervised to ensure that they do not play with the
appliance.Cleaning and user maintenance shall not be made by children without
supervision.
8. Do not stare at the hob elements when the appliance is working.
9. Accessible parts may become hot during use. To avoid burns young children
should be kept away
10.
If the surface is cracked, switch off the appliance to avoid the
possibility of electric shock, for hob surfaces of glass-ceramic or similar material
which protect live parts
11.Shall state a steam cleaner is not be used.
12.Metallic objects such as knives, forks, spoons and lids should not be placed on
the hob surface since they can get hot.
13.
The surface temperature exceeds 95°C.To avoid a hazard,under
bench access must be restricted.Refer to the installation instructions.
14.
The appliance and its accessible parts become hot during use. Care
should be taken to avoid touching heating elements.Children shall be kept away
unless continuously supervised.
15.The appliance is not intended to be operated by means of an external timer or
separate remote-control system.
16.
Unattended cooking on a hob with fat or oil can be dangerous and
may result in fire. NEVER try to extinguish a fire with water, but switch off the
appliance and then cover flame e.g. with a lid or a fire blanket.
17.
Danger of fire: do not store items on the cooking surfaces.
18.
The cooking process has to be supervised. A short term cooking
process has to be supervised continuously.
19.
Use only hob guards designed by the manufacturer of the cooking
appliance or indicated by the manufacturer of the appliance in the instructions for
use as suitable or hob guards incorporated in the appliance. The use of
inappropriate guards can cause accidents.
Swi
t
ch Knob
Heating area
(Φ180mm)
Heating area
(Φ180mm)
Heating area
(Φ180mm)
Heating area
(Φ180mm)
Heating area
(Φ145mm)
Heating area
(Φ145mm)
Heating area
(Φ145mm)
Heating area
(Φ145mm)
PRCEH104
For PRCEH104
, according to your needs, the tops can be adjusted by turning the knobs either
clockwise or anti-clockwise
to
9 position
s
besides the 0 position (off). The positions marked by the
higher numerical index match the maximum output of heat (see table).
When using rapid tops, a thermostat automatically reduces the power when the selected temperature
is reached and the top operates intermittently to reach a constant cooking temperature. The pilot light
set in the control is a signal that the electric
elements
are switched on. The level of heat can be
adjusted gradually by turning the appropriate knob to the right or left. Switching on the
element
results in an orange signal light
illuminating
on the control panel.
0
1-2
3-4
5-6
7-8
9
Switch off
MIN.Warming up
Stewing vegetables,
S
low cooking
Slow frying
Grilling meat,
fish
MAX.Fast heating up,
F
ast cooking,
F
rying
1-2
3-4
5
5
6
Time limit
(hours)
4
1.5
6-9
Power
level
1
2
3
