Pride Mobility Quantum TB3, Installation Instruction

Page: 1 / 2

Down Post Installation Instruction
TB3 Version 3 Flip-back Armrest
1
Rev A / August 2020
If you require any assistance with these instructions, please call Quantum Technical Service at
1-877-800-1248. Canada providers, call 1-888-570-1113.
NOTE: Only the right side is shown. The left side installation mirrors the right.
WARNING! Prior to performing any actions to the power chair, ensure the power is
turned off at the joystick and the power base is in drive mode.
NOTE: The following symbol will be used to indicate the size of the Hex Key needed in
millimeters. Example: is a 6 millimeter Hex Key. is an 8mm Hex Key.
#
mm
6
mm
8
mm
8
mm
14”-16”H 11”-13”H 8-10”H
Down Post Assemblies
Tools Required:
- Metric Hex Key Set
- Calibrated Torque
Wrench
- Measuring Tape
- Loosen the Mounting Hardware and Hinge
Screws. The Hinge Points should be loose but
remain connected.
Hardware shown removed for illustration purposes only.
Hinge Screws
Mounting Hardware
1
- Slide the receiver block into the side rail. The
Reverse orientation is used for 8” - 10” high armrests,
the Forward orientation is used for all other armrest
heights.
Back
Front
Back
Front
Reverse
Forward
Forward
Orientation
Shown
2
Hinge
Point
Hinge
Point
8
mm
6
mm
6
mm