PRG V476, User Manual

Page: 364 / 444

346 V676
®
/ V476
®
CONTROL CONSOLE USER MANUAL
The coordinates are based on a point of origin (X=0, Y=0, Z=0) from which every object in your 3D graphic has been
located. By defining all three locations, you can achieve an accurate representation of your production in the Graphic
Display window.
+ X - left/right from origin.
+
Y - forward/backward from origin.
+
Z - height from origin.
Note: The Z coordinate (height) sets the top position for the luminaire’s
hook in the 3D graphic. For example, to place a luminaire on a pipe at a
height of 20
’ -0" to the bottom of the pipe, the luminaire should be placed
at 20 ’ -2" for accurate placement.
3D Orientation
A fixture’s 3D orientation can be entered in the Orientation section of the Patch dialog at the time the luminaire is
initially patched or any time later.
Guidelines:
+ The Patch display shows the current orientation.
+
The defaults set the orientation to common starting positions.
+
The three angular controls allow adjustment.
Point of Origin
(0,0,0)
X
Y
Z