PRG V476, User Manual

Page: 287 / 444

V676
®
/ V476
®
CONTROL CONSOLE USER MANUAL 269
Board Cue Go/Back as Submaster 1 Go/Back
If no board cue is pending (by selecting a board cue via the command line or the board cue window), then the board
cue [Go] and [Back] buttons are mapped to Submaster 1 Go and Back. If a board cue is pending, then the board cue
Go/Back will perform normal board cue controls.
Note: To clear pending board cues, enter [Board Cue] [0] [Enter] on the command line.
Board Cues Window
The content of board cues can be viewed in the Board Cues window. This window displays all recorded board cues in
numerical sequence and provides data regarding linked events which would run during playback. Link attributes such
as loops and autofollow types (wait and trail) are visible as well as the associated times (refer to
"Special Cue
Attributes" on page 272). Unless links are provided, which will run cues out of sequence, any playback sequences will
observe the numerical order found in the sheet.
The Delete, Replace, Punch In, and Insert features allow editing so that an entire board cue does not have to be re-
recorded in order to make a change. The Time column may also be edited.
Access Board Cue Sheet:
Step 1. At Operation menu, select Board Cue Sheet . Board Cue Sheet window will open.
Step 2. If timing is desired, click in "T" column. A dot will appear in column indicating that
real timing will be used when playing back board cue. (Timing can be turned off at a
later time by clicking in the "T" column again.)
Board Cue
Number
Steps which are part
of the selected Board Cue
Snapshot link
Cue link
Auto Follow type (wait, trail, or none)
Auto Follow time
Number of
loop cycles
Timing information
(This can be edited)
Delete
Punch In
Replace
Insert
Toggles on/off timing feature
so that Board Cue plays back
with or without timing