PRG V476, User Manual

Page: 276 / 444

258 V676
®
/ V476
®
CONTROL CONSOLE USER MANUAL
Macros Data Window
The Macros window can be used to view macro information and to edit macro timing.
The macro Delete, Replace, Punch In, and Insert features allow macro editing so that an entire macro does not have
to be re-recorded in order to make a change.
Access Macros window:
Step 1. At Data menu, select Macros . Macros window will open.
Step 2. If timing is desired, click in "T" column. A dot will appear in column indicating that real timing will be used
when playing back macro. (Timing can be turned off at a later time by clicking in the "T" column again.)
Step 3. If required, click arrow at left of Steps to open Steps drop-down window. Edit times as required.
Delete a step:
Step 1. Using trackpad, select step(s) to be deleted.
Step 2. Click on "trash can" icon. Step(s) will be removed.
Replace a step:
Step 1. Using trackpad, select step to be replaced.
Step 2. Click "replace" icon. (Console [Macro Rec] button will begin flashing.)
Step 3. At front panel, perform replacement action. (The first action taken will replace the selected step and editing
will end.)
Replace all steps from Step X on (through remainder of macro):
Step 1. Using trackpad, select last "good" step. (Steps after this selection will be replaced.)
Step 2. Click "punch in" icon. (Console [Macro Rec] button will begin flashing.)
Step 3. At front panel, perform new series of actions.
Note: Macro can be updated or re-stored as a new number.
Timing information
(This can be edited)
Delete
Replace
Insert
Punch In
Macro Number
Indicates that timing is active for the macro