GROUNDCONTROL™ REMOTE FOLLOWSPOT SYSTEM™ USER MANUAL
19
Configuring the Reticle
Targeting crosshairs, referred to as the "reticle," are available in the the camera view. The position and size of the
reticle can be configured using the Settings menu.
To configure reticle:
Step
1. At Controller main menu, press CONFIG panel.
Step
2. At Configuration menu, press SETTINGS panel.
Step
3. At Settings menu, press
Reticle Setup
to bring up the reticle on the monitor.
Step
4. Use the three encoders below the touchscreen to adjust the reticle X Position, Y Position, and Size.
Figure 17: Reticle Adjustment
Step
5. Once the reticle is set as desired, press
Reticle Setup
again to exit the setup mode and save the reticle size
and position.
Note:
The reticle settings are persistent after power down.
Encoders
