PREVOST X3-45 VIP 2017, Owner'S Manual

Page: 99 / 212

Other Features 5-13
3. Distance to Empty
The left numerical value indicates the distance that can be traveled with the
quantity of fuel that remains in the tank as indicated by the right numerical
value.
TIME/DISTANCE
The time and date can be set in the Time/Distance menu. The alarm clock can also be set from this
menu. Following the alarm clock menu is the Trip Odometer 1 and 2 selection, which allows the operator
to see the distance travelled since the last reset. Average trip speed is also shown. By specifying the
distance to your destination, the vehicle can calculate the estimated time of arrival (ETA).
1. Time And Date
Adjust time and date with this menu. The instrument cluster has its own
internal battery, so the date and date setting is keep in memory even if the
vehicle’s battery is disconnected.
2. Alarm Clock
Use this function to program and activate an alarm on the instrument cluster
clock. When the alarm clock goes off, a warning signal is sounded. The alarm
shuts off after 60 seconds or if the ESCAPE button is depressed.
3. Trip Odometer 1 and 2
Allows the operator to see the distance travelled since the last reset. You can
reset the trip odometer 1 or 2 in this menu. To reset, depress ENTER button,
use UP/DOWN button to select between odometer 1 or 2 and then hold
ENTER button for 1 second.
4. Average Trip Speed
This function displays the average speed for the current travel. The average
trip speed is calculated as the distance traveled divided by the time the
engine has been running (since the last reset). Two average trip speeds can
be measured, corresponding to leg 1 and leg 2. Use Reset function before
each new travel to start new measurements.
5. Estimated Time of Arrival (ETA)
This function will display the estimated time of arrival if the distance to be
traveled is entered first, in this menu. To set distance to be traveled, press
ENTER and enter the distance left to drive in mile or km using ENTER and
UP/DOWN buttons.