PREVOST X3-45 VIP 2017, Owner'S Manual

Page: 44 / 212

Controls and Instruments 4-10
CIGARETTE LIGHTER (9)
Push lighter in to activate. When ready to use, it
will spring out automatically. Replace lighter in
non-activated position. The cigarette lighter
socket can be used to power 12-volt appliances
(e.g. flashlight, vacuum cleaner). The maximum
power consumption allowed for appliances
plugged in this socket is 130 watts. Make sure
the appliances are equipped with suitable plugs
that will not damage the socket.
NOTE
The cigarette lighter can still be used after the
ignition key has been removed.
ASHTRAY (10)
If no astray is installed, the space becomes an
accessory pocket.
To open the ashtray, push slightly on the cover’s
side. The ashtray can be removed for cleaning
by pulling it out.
WARNING
To prevent a fire, never put paper or plastic
wrappers in the ashtray. Empty ashtray often.
ACCESSORY POCKET (11)
To open the compartment, lift the cover.
12-VOLT DC POWER OUTLET (12)
This socket can be used to power small 12 volt
DC appliances such as a cellular phone or a
vacuum
cleaner. The maximum power
consumption allowed for appliances plugged in
this socket is 130 watts. Make sure appliances
are equipped with suitable plugs that will not
damage the socket.
TRAILER AIR SUPPLY CONTROL VALVE
(OPTION) (13)
The trailer air braking system is supplied by
pushing this control valve.
Diagnostic Data Reader (DDR) Receptacle
To facilitate troubleshooting of the Allison
Transmission and ABS systems and to obtain
data logged in the ECM (Electronic Control
Module) memory, a Diagnostic Data Reader
(DDR) (not supplied) can be connected through
the DDR receptacle. A user's manual is supplied
with the optional DDR.
The DDR receptacle is located inside the
footwell, on the upper left side wall.
AUTOMATIC FIRE DETECTION AND
SUPPRESSION SYSTEM (AFSS)
Protection Panel
The protection panel displays the current system
status. The protection panel contains “SYSTEM
OK”, fire “ALARM” and “TROUBLE” lamps, the
audio alarm, the “TEST/RESET” switch, and the
“ALARM SILENCE” switch.
The “SYSTEM OK” lamp indicates power is on
the system and that there are no trouble
conditions present. The “TROUBLE” lamp blinks
if there is a fault in the detection circuitry and
illuminates solid if there is a fault in the
extinguishing circuitry. When the “TROUBLE”
lamp is on, the “SYSTEM OK” lamp will be off
and the audible alarm will sound intermittently.
The “SYSTEM OK” lamp will flash when the
system is low on battery power. Depressing the
“TEST/RESET” switch tests the protection panel
lamps and audio alarm. The “ALARM SILENCE”
switch will disable the audio alarm.
When a fire detector automatically detects a fire,
the fire “ALARM” lamp and audio alarm activate.
When the Manual Activation Switch is activated,
the fire “ALARM” lamp blinks and the audio
alarm activates. The lamp will remain blinking
until power is cycled to the system.
AFSS PROTECTION PANEL & MANUAL ACTIVATION
SWITCH
Manual Activation Switch
The manual activation switch allows immediate
system activation (extinguisher discharge and
engine shutdown) by the operator at any time.
Activation of the switch is accomplished by