Controls and Instruments
4-6
connected directly to the batteries can be
activated. These are: the coolant heater and
water pump, the keyless entry system and anti-
theft alarm, the central locking system, entry
lights electric horn and Driver Information
Display (DID). Maintain the switch in this
position when parked overnight or for an
extended period.
Accessories
To operate the accessories only, turn the ignition
key counterclockwise. The key cannot be
removed in this position.
The battery electrical circuits are activated when
the switch is in this position or when the hazard
flashers are activated.
The features enabled when the key is in the
ACC position are all those linked directly to the
battery plus the exterior temperature display, the
radio or entertainment system, exterior and
interior lighting.
On
To place ignition switch to
ON
, turn the key
clockwise to the first position. The key cannot be
removed in this position.
The electrical circuits activated are the same
than when the switch is in the
ACC
position plus
the transmission, engine and accessories, ABS
system, wipers, level low system, dashboard
cluster gauges and buzzers, air horn and air
dryer heater are activated when the key is in this
position. Do not leave the key in this position
unless the engine is running.
Start
Turn the key clockwise to the second position
and release as soon as the engine starts. The
key will return to the ON position. If the engine
did not start, return the ignition key to the OFF
position before trying to restart the engine.
CAUTION
To avoid overheating the starter, do not
engage the starter for more than 15 seconds at
a time. Allow the starter to cool before trying to
restart the engine.
The features activated when the engine is
running are all those described above plus the
HVAC system and day time running lights. The
optional ether cold-start system is automatically
deactivated once the engine runs.
REMOTE ENTRY TRANSMITTER
Hand held transmitters (key FOB) can be used
to control the keyless door lock system.
To lock the entrance door and the baggage
compartment doors simultaneously and arm
the
intrusion
protection
and
anti-theft
system:
o
Press LOCK (top) button on the transmitter
once.
NOTE
The lock function will not function when the
ignition is in the ON position or the entry door
is open.
NOTE
The intrusion protection and anti-theft system
will be set after a 10 seconds delay.
To unlock the entrance door:
o
Press UNLOCK DOOR (bottom) button on
the transmitter. This will unlock the door and
disarm the anti-theft system.
To unlock the baggage compartment doors:
o
Press UNLOCK BAGGAGE (right) button.
This will not disarm the alarm.
To set off the personal security alarm (Panic
mode):
o
Press and hold the red (left) PANIC button
for two seconds. The horn will sound and
the marker lights will flash for 30 seconds.
To deactivate the personal security alarm:
Press any FOB button again or unlock the
entrance door using the keypad.
Summary of Contents for X3-45 VIP 2017
