PREVOST X3-45 VIP 2017, Owner'S Manual

Page: 31 / 212

Vehicle Interior 3-3
Fore-and-aft/Up-Down (2)
Push switch towards dashboard to move seat
forwards or back to move seat backwards. Pull
switch up to raise seat or push switch down to
lower seat.
SEAT CONTROLS
18040
Tilt (front) (3)
Pull switch up to raise front section of seat. Push
switch down to lower front section of seat.
DRIVER SEAT BELT
The driver’s seat is equipped with a retractable
safety belt as required by State, Provincial and
Federal regulations.
To fasten, pull seat belt out of the retractor and
insert the latch plate into the buckle until it clicks.
No special adjustment is required since the reel
device is self-adjusting. If seat belt operation
becomes defective, report to Manufacturer's
Service Center.
FASTENING SEATBELT
18028
NOTE
The safety belt must be pulled out slowly and
continuously, otherwise it will lock the reel
before the latch plate reaches the buckle. If
this happens, allow the belt to retract
completely and repeat the procedure correctly.
WARNING
A snug fit with the lap belt positioned low on
the hips is necessary to ensure motorist's
safety. The belt should not be worn twisted.
Avoid pinching belt and/or belt hardware in
seat mechanism. Do not wear belt over rigid or
breakable objects, such as eyeglasses, pens
or keys as these may cause injuries.
CAUTION
Never bleach or dry clean safety belt.
To unfasten belt, press the red button in center
of buckle and allow belt to retract. If the belt
does not fully retract, pull it out and check for
kinks or twists. Make sure that it remains
untwisted as it retracts.
DANGER
Safety belts should always be worn by
motorists using seats supplied with belts since
this is required by most State and Provincial
laws.