Care and Maintenance
8-14
VARIOUS LIGHTS LOCATION
FIRST SERVICE ON NEW VEHICLE
NOTE
Refer to Maintenance Manual for precise
service schedule.
ENGINE OIL
Preliminary oil change is not required since the
engine has been test-run at the factory. Change
oil and filter as specified in Section 24 of the
Maintenance Manual.
COOLANT SYSTEM FILTER
The coolant system filter is designed to recover
the soldering residues trapped inside the coolant
lines during their initial assembly. Clean filter
after first 3,000 miles (5 000 km) and then every
50,000 miles (80 000 km). Refer to the
Maintenance Manual under section 05: Cooling
System.
NOTE
If soldering has been performed on cooling
system, clean filter after 3,000 miles (5 000
km).
GENERAL RECOMMENDATIONS
o
Understand basic principles of vehicle
operation;
o
Always maintain the vehicle in good running
condition;
o
Do not drive with low fuel. If the fuel tank
runs dry, the engine will not start until the air
is bled from the fuel system. Refer to
"Maintenance Manual" for more information;
o
Allow engine to run for at least two minutes
at normal idle before shutting
OFF
;
o
Engine should be at idle when shifting from
neutral (N) to forward (D) or from neutral (N)
to reverse (R);
o
The automatic transmission does not have a
park (P) position. Place transmission in
neutral (N) position and apply parking brake
when the vehicle is stopped. A warning
Summary of Contents for X3-45 VIP 2017
