PREVOST X3-45 VIP 2017, Owner'S Manual

Page: 117 / 212

Other Features 5-31
NOTE
When air pressure is relieved using the shut-
off valve, the normal extending and retracting
operation cycle is disabled, for that reason the
slide-out cannot be moved using the control
pad.
PNEUMATIC CONTROL PANEL
3. To move the slide-out, use a cordless power
drill with a 3/8" hexagonal bit on the shaft
extension of the slide-out motor.
4. Rotate the slide-out motor shaft extension
with the power drill until the slide-out comes
to its closed position.
5. Once the slide-out room is lined up to its
closed position, remove the tool from the
motor.
NOTE
The front slide-out motor is located inside
the 2
nd
baggage compartment while the rear
slide-out motor is accessible from inside the
vehicle, under the bed structure.
SLIDE-OUT MOTOR ROTATION
CAUTION
Slow down on the closing speed as the slide-
out approaches its closed position. As soon as
the “in limit” stoppers come in contact with
their bearing surface, stop immediately the
power drill rotating movement. Not doing so
could overload the drive mechanism and
cause damage to the reduction gearbox.
6. Finally, the inflatable seal can be re-inflated
by turning the shut-off valve handle
counterclockwise. Check the pressure gage
on the inflatable seal regulator to see if the
pressure is increasing to around 11 psi.
Needle should point between the green
indicator pegs.
INFLATABLE SEAL PRESSURE GAGE
NOTE
The slide-out control system inhibits
transmission range selection to prevent the
vehicle from moving if the slide-out is not in its
full "IN" position.
Manual extending procedure – Front and rear
slide-out
1. Apply barking brake to disengage the
security pin from the receptacle.