PREVOST X3-45 VIP 2015, Owner'S Manual

Page: 157 / 190

Technical Information 9-5
DIMENSIONS AND
WEIGHTS
X3-45 VIP
Overall length
(including bumpers)
45' (13,7 m)
Overall width 102" (2,59 m)
Overall height 143” (3,63 m)
Wheelbase
(center of front axle
to center of drive axle)
334½”
(8496 mm)
Floor height from ground 48 1/2" (1,23 m)
Ground clearance 11" (280 mm)
Step height from ground 15" (380 mm)
Step height (other steps) 7" (178 mm)
Headroom
89”
(2261 mm)
Entrance door opening
width
30" (762 mm)
Front overhang 72¼" (1836 mm)
Rear overhang
82¾”
(2102 mm)
Front track 85.9" (2,18 m)
Drive track 76.7" (1,95 m)
Rear track 83.6" (2,12 m)
Turning circle radius
(exterior front corner)
44’-3”
(13487 mm)
X3-45 VIP
Curb weight
(before conversion)
N/A
Gross Vehicle Weight
Rating (G.V.W.R.)
55,500 lb
(25 174 kg)
Front axle Gross Axle
Weight Rating (G.A.W.R.)
19,000 lb
(8 618 kg)
Drive axle (G.A.W.R.)
22,500 lb
(10 206 kg)
Tag axle (G.A.W.R.)
14,000 lb
(6 350 kg)
The Gross Vehicle Weight Rating (G.V.W.R.)
and the Gross Axle Weight Rating (G.A.W.R.)
for front drive and tag axles are listed on a
certification plate located on the L.H. control
panel in driver's section.
CAPACITIES
X3-45 VIP
Volvo D13 Engine
oil (in crankcase)
38 U.S. qrts (36 l)
Fuel tank
(legal capacity equal
to 95% of volume)
208 U.S. gal. (787 l)
Cooling system 24 U.S. gal. (91 l)
Allison Transmission
(does not include
external circuit) 6 U.S. gal. (23 l)
6.9 U.S. gal. (26 l)
with retarder
Differential oil 20 U.S. qts (18,7 l)
Power steering
reservoir
4.0 U.S. qts (3,8 l)
A/C compressor oil 4.5 U.S. qts (4,3 l)
Windshield washer
reservoir
5.3 U.S. gal. (20 l)
Refrigerant 24.1 lb (11 kg)
Toilet septic tank
23.8 US gal.
(90 liters)
FUEL TYPE
Diesel engines for 2007 and later model year
vehicles are designed to operate only with
Ultra
Low Sulfur Diesel (ULSD) fuel, which can
contain no more than 15 ppm sulfur.
CAUTION
ULSD fuel is necessary to avoid fouling the
engine’s Exhaust Aftertreatment System. Use
of fuel other than ULSD will reduce the
efficiency and durability of the engine.
BIODIESEL FUELS
Biodiesel up to a maximum of 20% blend (B20)
may be used and will not affect the
manufacturer’s mechanical warranty as to
engine and emissions system related
components, provided the biofuel used in the
blend conforms to ASTM D6751, B1 to B5
blends conform to ASTM D975, and B6 to B20
blends conform to ASTM D7467. Also, any
engine performance problem related to the use
of biodiesel fuel would not be recognized nor
considered as Volvo or Prevost’s responsibility.
However, Volvo engines are certified to comply
with U.S. EPA and California emissions
standards based upon the use of
test fuels with