PREVOST X3-45 VIP 2015, Owner'S Manual

Page: 152 / 190

Care and Maintenance 8-18
front of the ACB radar sensor, if
applicable.
STEP 3: FRONT RIGHT SIDE OF THE
VEHICLE
•
Check condition of wheel rim. Especially
look for cracks, missing nuts, bent or
broken studs.
•
Check condition of tire: properly inflated,
no serious cuts, bulges, tread wear or
any signs of misalignment; valve stem
not touching wheel or rim; valve cap in
place.
STEP 4: REAR RIGHT SIDE OF THE VEHICLE
•
Check condition of wheels and rims.
Especially look for cracks, missing nuts,
bent or broken studs.
•
Check condition of tires: properly
inflated, no serious cuts, bulges, tread
wear or any signs of misalignment; valve
stems not touching wheels or rims; valve
caps in place and no objects stuck
between the wheels.
STEP 5: ENGINE COMPARTMENT RIGHT
SIDE AREA
•
Check engine and surrounding areas for
coolant, oil and fuel leaks.
•
Check fuel/filter water separator and
drain if necessary. Check for leaks.
•
Check wiring harness for signs of
damage.
STEP 6: ENGINE COMPARTMENT
•
Check engine and surrounding areas for
coolant, oil and fuel leaks.
•
Check wiring harness for signs of
damage.
•
Check condition of drive belts.
•
Check engine crankcase oil level, add if
necessary.
•
Check Allison transmission fluid level
(can also be checked from push-button
shift selector), add if necessary.
•
Check power steering reservoir fluid
level, add if necessary.
•
Check coolant surge tank fluid level, add
if necessary.
•
Check air cleaner restriction indicator,
replace air cleaner when red signal locks
in full view.
•
Check stop light, tail light, directional
signal light and back-up light assembly;
operating, clean and proper color. Refer
to “Exterior Lighting Verification” in Care
and Maintenance chapter.
STEP 7: REAR LEFT SIDE OF THE VEHICLE
•
Check condition of wheels and rims.
Especially look for cracks, missing nuts,
bent or broken studs.
•
Check condition of tires: properly
inflated, no serious cuts, bulges, tread
wear or any signs of misalignment; valve
stems not touching wheels or rims; valve
caps in place and no objects stuck
between the wheels.
INSIDE THE VEHICLE
•
Check for proper operation of the
entrance door.
•
Check steps; clean them if there is any
substance that makes them slippery,
which makes vehicle
entry/exit
hazardous.
•
Check that emergency exit windows can
be opened then close all windows
securely.
•
Verify proper operation of windshield
wiper/ washer.
•
Adjust and clean mirrors for adequate
rear view vision.
•
Start engine and check for proper
operation of all gauges and indicator
lights.
•
Check for proper operation of electric
and air horns and back-up alarm.
•
Perform a brake test. Check both
primary and secondary pressure
gauges.