PREVOST X3-45 VIP 2015, Owner'S Manual

Page: 104 / 190

Other Features 5-26
o
Enter your personal or the default validation
code followed within 5 seconds by the 1/2
key.
To unlock the baggage and service
compartment doors:
o
Enter your personal or the default validation
code followed within 5 seconds by the 5/6
key.
To unlock all doors simultaneously:
o
Enter your personal or the default validation
code followed within 5 seconds by the 3/4
key.
To lock the doors and activate the anti-theft
system:
o
Press the 9/0 key for 2 seconds (no
validation code required).
NOTE
The lock function will not function when the
ignition is in the ON position or the entry door
is open.
NOTE
After repeated attempts to enter codes (20
button presses without enabling), the keypad
will enter in an inactive mode that disables
buttons for 60 seconds. The lock indicator will
flash amber and red during this state.
If a partial validation code is entered or no
action button is pressed within 5 seconds, the
keypad will revert back to disabled condition
and the access code will have to be entered
again.
PROGRAMMING AND MANAGING
PERSONAL CODES
It is possible to program up to 40 four (4) digits
personal access codes to unlock the entrance
door and compartments. These codes do not
replace the default code that is factory supplied
with the vehicle.
When programming codes, do not choose
codes that present the numbers in sequential
order, studies show that people who idly press
the buttons usually press a sequential pattern.
Also, do not select a code that uses the same
button four times. Thieves can easily figure out
these types of codes.
To add a new personal code:
o
Choose and memorize a four (4) digits
personal code.
o
Press and hold the 5/6 key for five seconds
(keypad will start to beep and flash).
o
Enter the vehicle factory six (6) digits
authority code.
o
Press the 1/2 key (a short beep will be
heard, validating the action).
NOTE
If the 40 codes memory is already full, a long
beep will be heard.
o
Enter the chosen personal code (three
confirmation beeps will be heard).
o
Re-enter the code to confirm the entry (four
confirmation beeps will be heard).
Press the 1/2 key and repeat the last two steps
to enter additional codes.
To delete a personal code:
o
Press and hold the 5/6 key for five seconds
(keypad will start to beep and flash).
o
Enter the vehicle factory six (6) digits
authority code.
o
Press the 3/4 key (a short beep will be
heard, validating the action).
NOTE
If the 40 codes memory is already empty, a
long beep will be heard.
o
Enter the code to be deleted (three
confirmation beeps will be heard).