Presto Lifts ECOA PDL60-50, Owner'S Manual, Page: 22 / 30

22
Presto Lifts PDL Manual
6.3 Adjusting Vertical Travel Limit Devices
If the lift reaches the end-of-travel before the vertical travel limit device
turns off the HPU, immediately release the button. Do not continue to
power the lift once the lift reaches the end-of-travel or the lift may be
damaged.
6.3.1. Mechanical Limit Switches
The limit switch should be adjusted such that the switch opens and the power unit turns off just
before the lift reaches the desired raised height. The lift will drift up slightly after the power unit
turns off.
To adjust the limit switch:
1. Raise the lift and engage the maintenance device(s). See section 6.1 Maintenance
Devices .
2. Loosen the locking nut on the striker.
3. Thread the striker in or out as needed to achieve the desired raised height. Make small
adjustments and check for the correct raised height in between adjustments.
• Threading the striker in will increase the raised height.
• Threading the striker out will decrease the raised height.
4. Retighten the locking nut on the striker to prevent the striker from moving during operation.
5. Disengage the maintenance device(s) and check the raised height.
6. Repeat steps 1-5 until lift comes to a stop at the desired height.
LIMIT SWITCH
LOCATION
***SWITCH BODY
HIDDEN FOR
CLARITY
SWITCH ARM
STRIKER
LOCKING NUT THREAD STRIKER IN TO INCREASE
RASIED HEIGHT, THREAD OUT TO
DECREASE RAISED HEIGHT