7.2.7 Changing the Signal Chain
74
7.2.5 Tube Leveling Amplifier
电子管调平放大器
1.
On/Off.
Turns the Compressor on or off in the signal chain.
2.
Gain.
Sets input gain to the compressor. Because this type of compressor operates in a different way
than a standard compressor, much of the way that it affects signals is based on the input level. Try dif-
ferent settings to see what suits your needs.
3.
Peak Reduction.
Sets the amount of peak reduction to apply to the signal. Higher settings result in
more gain reduction and more pronounced compression effect.
4.
Compressor/Limiter Toggle.
The button below toggles the Tube Leveling Amplifier between its
compressor and limiter modes. When in compressor mode, it acts with a variable ratio of 1:1-10:1.
When in limiter mode, it acts with a variable ratio of 10:1-20:1, more aggressively limiting peaks.
5.
Key Filter.
This sets the frequency at which the Tube Leveling Amplifier will engage. It will still pro-
cess the entire frequency range, but it is only engaged when the specified frequency is present.
6.
Key Listen.
Press to listen to the signal being used to trigger the compressor, as set with the Key Fil-
ter control (including the effects of the high-pass filter). Press again to switch back to the normal chan-
nel signal.
1
.
开
/
关。在信号链中打开或关闭压缩器。
2.
增益。设置压缩器的输入增益。因为这种类型的压缩器的工作方式与标准的压缩器不同，所以它影响信
号的方式主要是基于输入电平。试试不同的设置，看看什么适合你的需要。
3.
峰值降低。设置应用于信号的峰值降低量。较高的设置会导致更多的增益减少和更明显的压缩效果。
4.
压缩器
/
限幅器的切换。下面的按钮可以在压缩器和限制器模式之间切换电子管均衡放大器。当处于压缩
器模式时，它以
1:1-10:1
的可变比率工作。当处于限制器模式时，它以
10:1-20:1
的可变比率工作，更积极
地限制峰值。
5.
按键滤波器。这设置了电子管均衡放大器的频率。它仍将处理整个频率范围，但只有当指定的频率出现
时，它才会参与。
6.
键听。按这个键可以听用于触发压缩器的信号，正如用
Key Filter
控制所设定的那样（包括高通滤波器的
效果）。再按一下，就会切换回正常的通道信号。
