PRESONUS Eris HD10BT, Owner'S Manual

Page: 9 / 14

7
2.2. Left Earpiece Connections andControls
左耳机的连接和控制
2. Hookup
2.2. Left Earpiece Connections andControls
Eris HD10BT
Owner’s Manual
2.1.4. Hardwiring
线连接
Your Eris HD10BT headphones can be used wired when the battery is
low, or if you would like to connect them a device that does not offer
Bluetooth. The 1/8” TRS jack is located on the bottom of the Right
Earpiece. Use the included cable or any standard 1/8” TRS cable.
你的
Eris HD10BT
耳机在电池电量不足时可以使用有线方式，或者
如果你想连接不提供蓝牙的设备。
1/8 "TRS
插孔位于右耳机的底
部。使用附带的电缆或任何标准的
1/8" TRS
电缆。
2.2.1. Active Noise Canceling (ANC)
主动降噪
On the bottom of the Left earpiece, you will find Active Noise
Canceling (ANC) switch. Active Noise Canceling can be used
independently from Bluetooth listening. However, ANC does require
that your Eris HD10BT headphones be powered on.
在左耳机的底部，你会发现主动降噪（
ANC
）开关。主动降噪可
以独立于蓝牙收听而使用。然而，
ANC
确实需要你的
Eris HD10BT
耳机处于通电状态。
Note: Using ANC will reduce your battery charge at a faster rate than
simply using Bluetooth wireless.
注意：比起仅使用蓝牙无线技术，使用
ANC
会以更快的速度减少
你的电池电量。
When ANC is active, the adjacent LED will illuminate green.
当
ANC
处于激活状态时，相邻的
LED
灯将亮起绿色。