2
Application and Deployment
2.8
Pole Mounting Options
CDL12P
Owner’s Manual
9
2.8.2
Pole Mounting Instructions
1. Select the pole socket angle for your application (0˚ or 7.5˚).
Note: When mounting (2) CDL12P loudspeakers, the 7.5˚ tilt mount must be utilized
.
2. Carefully place one CDL12P on the loudspeaker pole by
inserting the pole completely into the pole socket.
3. If mounting (2) CDL12P loudspeakers on one pole, place
the lower loudspeaker on the pole first, then rig the top one
to it following the instructions in
Section 2.8.1
.
Important:
Use proper lifting techniques to avoid injury. It is highly recommended
that you team lift CDL12 loudspeakers onto their pole
mount for maximum safety and to avoid injury.
The following pole mounting options are supported:
• (1) CDL12P on Tripod Stand
• (2) CDL12P on Tripod Stand
WARNING:
The (2) CDL12P loudspeakers must be rigged to one another.
See Section 2.8.1 for instructions
.
• (1) CDL12P atop (1) CDL18s, (1) ULT18, or (1) AIR18s
WARNING:
Maximum pole height from the top of the CDL18s to the
bottom of the CDL12P cannot exceed 40”. PreSonus
recommends the K&M 21339.000.55 Crank Stand.
• (1) CDL12P atop (2) CDL18s
WARNING:
Other stacked subwoofer configurations are not supported.
Maximum pole height from the top of the upper CDL18s
to the bottom of the CDL12P array cannot exceed 17”. PreSonus
recommends the K&M 21334.050.55 Distance Rod.
The (2) CDL18s must be rigged to one another.
See
CDL12P Owners Manual for instructions
.
• (2) CDL12P atop (1) CDL18s
WARNING:
PreSonus only supported pole mounting (2) rigged CDL12P
atop a PreSonus CDL18s subwoofer. No other subwoofers are
supported for this application. The maximum pole height from the
top of the CDL18s to the bottom of the CDL12P cannot exceed 33.5”.
PreSonus recommends the K&M 21339.000.55 Crank Stand.
The (2) CDL12P must be rigged to one another.
See Section 2.3.1 for instructions
.
