24
PreSonus AudioBox
™
22/44VSL
Ov
er
view
Hook
up
Connec
ting
to a
Comput
er
Sof
tw
ar
e: V
irtual
StudioLiv
e
SL Remot
e,
and S
tudio O
ne Ar
tist
Tut
orials
Technical
Informa
tion
Troubleshooting
and W
arr
an
ty
4
Software: Virtual StudioLive and Studio One Artist
Sof
tw
ar
e: V
irtual
StudioLiv
e
and S
tudio O
ne Ar
tist
24
High Pass Filter Freq
Adjust the High Pass Filter’s Cutoff Frequency.
The High Pass filter’s cutoff frequency can be set from 18 Hz to 1.3 kHz.
Remember that all frequencies below a high-pass filter’s cutoff
frequency are attenuated. See Section 5.3.1 for more details.
The slope of the High Pass filter is -6 dB/octave.
The High Pass Filter is accessible from the Main VSL Page as well as the
Gate Zoom.
Power User Tip:
A high-pass filter attenuates all frequencies
below the set threshold. Use this filter, instead of an equalizer, to
remove unwanted low frequencies from your source signal.
Gate On/Off Button
Turns the Gate On and Off for the Selected Channel or Bus.
This button engages and disengages the gate for the selected channel. It
will illuminate to indicate that the gate has been enabled.
The gate is available for all input and output buses.
Gate Threshold
Sets the Threshold of the Gate for the Selected Channel or Bus.
The Gate Threshold determines the level at which the gate will open.
Essentially, all signals above the threshold setting are passed through
unaffected. You can set the threshold from 0 to -84 dB.
The Gate can be controlled either via the
Threshold knob or from the Gate Graph.
Compressor On/Off
Turns the Compressor On and Off for the Selected Channel or Bus.
This button engages or disengages the compressor for the selected
channel or output bus. It will illuminate to indicate that the compressor
has been enabled.
The compressor is available for all input and output buses.
Auto Mode Button
Enables Automatic Response Mode.
When Auto mode is active, the Attack and Release controls become
inoperative, and a preprogrammed attack and release curve is used. In
this mode, the attack is set to 10 ms, and the release is set to 150 ms. All
other compressor parameters can still be adjusted manually.
4.1 Virtual Studio Live
