MA-5191A
21-10-2021
4
/
110
1.
WARNING:
To prevent accidents and injuries
, the following safety instructions for handling our equipment must
be observed.
For your own safety, you must have read and understood the relevant safety instructions before working
with the equipment.
Keep the safety instructions in a place accessible to all persons working with the equipment so that
they can refer to them.
Our equipment should
only be handled
by experienced and appropriately authorised personnel
.
Error messages.
These must be observed under all circumstances; the cause must be located and
eliminated.
Warnings regarding sources of danger.
When handling or accessing the inside of the device,
conductive parts represent a potential hazard.
Voltage in general.
The device operates with a maximum voltage of 230 VAC. This voltage is
dangerous and can cause personal injury in case of contact with conductive parts of the equipment.
The conductive parts inside the equipment are considered especially hazardous areas. These may
include: various soldering points, printed conductors, terminals for mains connection, relay contacts,
etc. Before opening the device, disconnect the mains voltage from all poles.
External voltages. When disconnecting a piece of equipment, it is also necessary to consider possible
external voltages and feedback of the powered equipment.
Fuses.
Only original fuses should be used, in accordance with the equipment.
Use in accordance with the intended purpose.
The device must only be used for its intended
purpose. Any use not in accordance with the purpose is prohibited. PREMIUM S.A. cannot be held liable
for damages resulting from improper use. In such a case, the user must assume sole responsibility for
the risk. Use in accordance with the intended purpose is defined in the documentation. The device may
only be exposed to permissible environmental influences. These are specified in the technical data of
the equipment.
Prohibition of arbitrary modifications.
The equipment must not be modified with respect to
construction or safety technology without our express consent. Any modification excludes a liability on
our part for damage caused by the modification. In particular, all repair work, soldering on printed
circuit boards and the replacement of components, modules and printed circuit boards are forbidden
without the express authorisation of PREMIUM S.A.
If spare parts are used, only original PREMIUM
S.A. parts must be used. PREMIUM S.A. declines any liability resulting from an inadequate, negligent
or incorrect installation of the equipment, or from an incorrect connection of the equipment.
Due to the policy of continuous improvement, the content of this manual is subject to change without
notice.