6.
7.
4.
2.
INSTALLATION STEPS: Single handle lavatory faucet
1a.
5.
3.
1b.
Cleaning:
To maintain and protect the fine luster of all products, clean with a soft, damp cloth
only. DO NOT USE detergents or cleansers as they may harm the protective finish.
Model Number: 120125 & 120122
INSTALLATION
8.
1
2
3
Push lift rod (1) through hole in bottom
of body then reattach lift rod knob (2).
Tighten screw (3).
Escutcheon Installation (optional).
Place gasket (1) on bottom of new faucet.
Place faucet through mounting holes in
sink. Secure faucet to sink using washer
(2) and nut (3) provided.
1
3
2
1
Shut off water supply. Remove old faucet.
Flange Installation (optional).Place Flange
(1) on bottom of new faucet.Place faucet
through mounting holes in sink. Secure
faucet to sink using washer (2) and nut (3)
provided.
3
1
2
Attach horizontal rod (1) to strap (2) using
clip (3).
Important : After installation is completed,
remove aerator. Turn on water supply and
allow both hot and cold water to run for at
least one minute each. While water is
running, check for leaks. Replace aerator.
Tighten nuts slightly to stop minor leaks. If
problems persist, refer to troubleshooting
chart.
3
2
3
1
2
Making the waterline connections:
Use 1/2 in. I.P.S. faucet connections (2, not
included), or use the coupling nuts (3, not
included) with a 3/8 in. O.D. ball-nose riser (1, not
included). Before tightening the faucet connector
to the water supply, apply a second wrench to the
supply tube fitting. This will prevent the supply
tube from moving or twisting when tightening the
faucet connector. Do not overtighten.
NOTE: The hot side inlet tube is indcated by a
label. If the label is not present, the hot supply
tube is the longer of the two inlet tubes.
Brand Lavatory Faucets
Tools:
Adjustable wrench
Groove joint pliers
Pipe wrench
Screwdriver
Thread sealant tape
Basin wrench
Plumber's putty
6
8
3
11
7
9
5
4
2
1
10
Remove the stopper (1) and the flange
(2). Screw the brass nut (3) all the way
down. Push the plastic washer (4) and
the gasket (5) down. Unscrew the pivot
nut (6) from the pop-up body (7) and
remove the seal washers (8). Take off
the spring clip (9) from the horizontal rod
(10). Remove the tailpiece (11) from the
pop-up body (7).
2
3
4
5
1
Apply the silicone to the underside of the flange
(2). Insert the pop-up body (1) into the drain hole
from below sink. Screw the flange (2) into the
pop-up body (1). With the pivot hole (3) facing
toward faucet, Use groove joint pliers to tighten
the nut (4), do not over tighten. Do not turn the
pop-up while tightening the nut, or sealant may
not seal drain. Clean excess putty. Apply thread
sealant tape to the top threads of the tailpiece (5)
in a clockwise direction, as shown and hand
tighten.
4
3
1
2
Install the horizontal rod (2) and the
stopper (3) as shown (4). Hand tighten
the pivot nut (1).
