5
C
ALL
H
ANDLER
6000 I
NSTALLATION
I
NSTRUCTIONS
Installation Instructions
1) Mount the Call Handler on the Wall
2) Break each phone line between the demarcation block and
the inside phone system. Install one of the provided RJ31X
blocks in series (not in parallel) with each phone line. Do not
plug the RJ45 (8 wire) patch cord into the RJ31X blocks at
this time.
When using the RJ31X blocks provided with the Call Handler,
make the following connections:
• Connect the outside phone line to terminals 4 & 5 of the
RJ31X.
• Connect the inside phone line to terminals 1 & 8 of the
RJ31X.
3) Plug the AC adapter into a 120VAC outlet. Power-up the Call
Handler by plugging the AC adapter mini-plug into the 10VAC
power connector on the Call Handler. Verify that the LCD
display is operating. The display will indicate the current
operating mode for each of the 3 lines.
If the Call Handler is pre-downloaded, skip to step # 6.
4) Connect one RJ45 phone line patch cord from one of the
phone line connectors on the Call Handler to the RJ31X block
on the phone line that will be used for downloading. The Call
handler will intercept calls on that phone line only. Don’t
connect the other phone lines to the Call Handler yet,
because we want to first get the Handler downloaded and
configured properly.
