Page 1
Installation Instructions
Installation Instructions
9531-000-051-00
Parts List
The MM-CB3 is a triple multimonitor mount arm that works with any
2” tubing. Each mounting head provides 90° of omnidirectional tilt.
The mounting heads include both 75x75mm and 100x100mm VESA
mounting patterns. The arm includes integrated cable management
tabs to keep wires and cables protected and organized. The mounting
heads can be horizontally adjusted.
Introduction
MM-CB3
Step 3
MM-CB3
Triple Multi Monitor Mounting Arm
(Qty 1)
M4 x 10mm Combo Screws
(Qty 12)
5/32” Allen Key
(Qty 1)
M6 x 8 Truss
Head Screws
(Qty 2)
Loosen
& Adjust
Tighten
& Secure
Step 1
1)
Slide your mounting arm adapter bracket over the pole and base (Figure 1)
(not included, but should be previously installed).
Determine the position on the pole desired
for your mounting arm.
2)
Tighten the two (2) pre-installed M8 x 6mm
set screws in the back of the MM-CB3
adapter bracket. Tighten with included
allen key when in desired position.
Figure 1
Step 2
1)
Slide the left mounting head over the left arm until it is in the desired
position (Figure 2). Repeat for the right mounting head.
The center mounting head will be installed in a later step.
To tighten down and adjust the position of your
displays
2)
Turn the mounting head adjustment
knob counter clockwise until the mounting
head is lose enough to slide easily along
the pole.
3.
Slide the display (or mounting head) to the
desired position.
4.
When in place, turn the adjustment head clockwise to tighten it. Make sure
it is completely secure and does not move before you move on to the next
display or finish (Figure 3).
5.
Repeat steps for other displays if desired.
Figure 2
M8 x 40mm Button
Head Screws (Qty 4)
6mm Allen Key
(Qty 1)
1)
Slide one arm (with now installed mounting head) back into the
pre-installed arm adapter bracket.
2)
Once the arm is lined up with the holes in the arm adapter bracket, insert
two (2) M8 x 40mm button head screws per arm (Figure 4)
3)
Use the 6mm allen key to tighten the screws.
Do not overtighten the mounting hardware
4)
Repeat step for the second arm.
(Figure 3)
(Figure 4)
Step 4
1)
Install the center head bracket by aligning the screw holes with those in the
center where the two previously installed arms come together
(Figure 5)
2)
Use the two (2) M6 x 8 Truss Head Screws to attach the bracket to the
mounting arms.
Do not overtighten the mounting hardware
(Figure 5)
4” Cable Ties
Qty (2)
Socket Wrench
(Qty 1)
3100 E. Miraloma Avenue, Anaheim, CA 92806 | 800.368.9700 USA | F 800.832.4888 |
www.mounts.com
Unit 3, The Moorings Business Park, Channel Way | Longford, Conventry, CV6 6RH, UK |
+44 (0) 2476 644105 | F +44 (0) 2476 644165
