AM80
Installation Instructions
Visit the Premier Mounts website at http://www.premiermounts.com
Page 17
Cable Management
Fully extend the swingout arm away from the
wall.
®
If necessary, remove the plastic cap(s) to
access one or both of the cable access ports.
The cable access ports allow you to route
the cables through the base of the mount
and into the wall.
¯
Route all cables along the mount.
°
Use the two (2) supplied cable ties to attach
the cables to the mount as shown.
±
Cut off any excess cable tie.
Finish the Installation (cont’d)
Tension Adjustment
The mount is shown upside down to demonstrate
how to access the adjustment nuts.
The mount comes pre-tensioned from the factory.
To adjust the swingout arm tension:
Remove the three (3) plastic end caps.
®
Use a socket wrench with the supplied 14mm socket
to tighten/loosen the three (3) adjustment nuts to the
desired tension.
¯
Reinstall the three (3) plastic end caps.
Plastic End Cap (3)
Adjustment Nut (3)
Cable
Cable Tie (2)
Cable Access
Port (2)
