Precor TRM10/GEN06, Service Manual

Page: 94 / 149

© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 92
Replacing Drive Motor
1
Set the treadmill's on/off switch in the off position and unplug the
treadmill’s line cord from the AC outlet.
2
Remove the hood.
3
Disconnect the drive motor connector from the OUTPUT connector on the
power control module.
4
Remove the drive belt from the drive motor.
5
Mark the outline of the current motors mounting plate for reference
when you install the new motor.
6
Remove the four bolts that fasten the drive motor to the frame.
7
Set the replacement drive motor in its mounting position and fasten
the drive motor with four mounting bolts removed in step 5 and fasten
the drive motor with four mounting bolts removed in step 6.
8
Place the drive belt on the drive roller pulley and on the drive motor
pulley.
9
Adjust the drive belt tension and complete the motor installation per
Procedure, Adjusting Drive Belt Tension.
10
Thoroughly check the treadmill per,
Checking Treadmill Operation
(see
"
Section 4 - Operation Verification
" on page 9).