DIAGNOSTIC TEST
TEST DESCRIPTION
Beeper Test
Beeper sounds once every second.
Keypad Test
Press all hard keys and verify change to the pattern. The test will
exit when all keys have been pressed. Pressing down
Workouts
for 5 seconds also exits the test.
LCD Test
Test will light up all segments and sections of the display.
Heart Rate Test
Heart rate is acquired and displayed.
Belt Speed Test
Menu:
Machine Test
>
Belt Speed Test
Range: 0.5 mph to 12.0 mph in 0.1 increments.
l
Press
Go
to start the Belt Speed Test
(IMPORTANT
the
running belt will start movint).
l
Use the SPEED control to very speed.
Incline Test
Use controls to raise/lower incline to verify the following incline
angle A/D values:
l
Nominal value: 13 ±5 @ -2% incline
l
Nominal value: 37 ±5 @0% incline
l
Nominal value: 242 ±5 @ 15% incline
Information Display (65)
Service Access Code:
65
(see
"R20 How To Access Standard Service menus" on page 28
)
The Information Display provides the equipment usage information, software pn/version
information, and Error Log access.
INFORMATION DISPLAY
DESCRIPTION
ODOMETER
The total number of accumulated miles (or kilometers) on
the unit.
This value is stored in the upper PCA in the console so if
the PCA is replaced the accumulated miles would start
again from "0".
HOUR METER
The total number of hours that the unit took to accumulate
unit miles.
This value is stored in the upper PCA in the console so if
that PCA is replaced the hours of use would start again
from "0".
Contact Precor Customer Support at [email protected] or 800.786.8404 with
any questions.
Page 32
4 Standard Service Menus
Information Display (65)
