Precor TRM 425, Service Manual

Page: 21 / 146

l
Consoles and PVS
1
displays : a diluted solution of one part 91% Isopropyl alcohol
to one part water.
Cleaning Procedure
Generic cleaning procedure applicable to all Precor equipment:
TIP : There are many product specific PREVENTATIVE MAINTENANCE cleaning
videos available on the Precor Connect SERVICE VIDEOS web page. Log in to
your Precor Connect servicer account and select SERVICE VIDEOS, see
SERVICE VIDEOS .
1. Wipe down equipment using a soft lint-free cloth using only the recommended clean-
ing solution. Always spray cleaning solution directly onto the cleaning cloth and not
directly onto the equipment surface to avoid equipment damage due to excessive
moisture.
CAUTION : Do not use acidic cleaners and do not spray directly onto the equipment
surfaces.
2. Rinse surfaces using a clean lint-free cloth dampened with water only.
3. Then completely dry with another clean lint-free cloth.
Power Requirements
Equipment Power Requirements
The equipment input power from the wall outlet receptacle must be a good quality and
stable power signal (not fluctuating or intermittent) to insure the best performance and
trouble free operation.
Power Specification
l
120 VAC
2
60 Hz
3
models
o
Operating voltage: 90 VAC to 132 VAC.
o
AC frequency range: 47 - 65 Hz
o
15 amp individual branch circuit
1
Personal Viewing System display.
2
voltage in an alternating current circuit
3
The hertz (symbol: Hz) is the derived unit of frequency in the International System of Units
(SI) and is defined as one cycle per second.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions. Page 14
2 General Information
Cleaning Procedure