page 13
C
O
M
M
E
R
C
I
A
L
P
R
O
D
U
C
T
S
D
I
V
I
S
I
O
N
Diagram 5
Installing the covers.
Rear bracket cover
Split rubber
grommet (H)
Upright support tube
1
2
RJ45 cable
Center tube
Front bracket cover
Diagram 4
Connect the cable.
Cable receptacle
Base frame support
Cable connector
Buttonhead
screws (C)
CAUTION: Do not stretch, crimp, or damage the cable. Excess cable may be
gently pushed into the upper support tube. Cables damaged by improper
installation will not be covered by the Precor Limited Warranty.
7.
Connect the cables. Diagram 3. Insert the cable into its receptacle. Just like a
telephone connection, a definite "click" is heard when a good connection is
made. If you do not hear a "click," try reinserting the cable again. Place the
excess cable inside the upright support tube.
8.
Install the bracket covers. Diagram 5. Remove the 2 bracket covers, the
split rubber grommet (H) and four buttonhead screws (C) from the Hardware
kit. Then, take the following steps:
a. Use two buttonhead screws (C) to attach the rear bracket cover to the center
tube. See Diagram 5, #1. Tighten the screws with the hex key provided.
b. Position the split rubber grommet (H) around the upright support tube. Slide
the grommet against the rear bracket cover to help secure it in place.
c. Use the remaining two buttonhead screws (C) to install the front bracket
cover. Align the mounting holes and tighten the screws. See Diagram 5, #2.
CAUTION: Do not overtighten the screws or you may inadvertently crack
the plastic covers. Damaged covers due to improper installation will not
be covered by the Precor Limited Warranty.