Precor Discovery DSL0314, Assembly Manual

Page: 59 / 68

Diverging Lat Pulldown Assembly Guide: Routing the Cable Assembly 9
The cable is wrapped in packing material and attached to the equipment frame
for shipment. Proper cable routing is shown in the following figure.
To route the cable on the movement frame:
1. Screw both ends of the upper cable into the cable ends located on the
movement arms. Using a
³₄
-inch wrench, tighten to 600 in-lb (68 N-m) of
torque.
Figure 11: Upper cable route
2. Check that the lower cable is properly routed on the lower pulley.
Figure 12: Lower cable route
Routing the Cable Assembly