Precor AMT12 base, Service Manual

Page: 118 / 276

© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 118
29 Loop the end of the flat belt to the 10 inch mark. While holding the flat belt end on the 10 inch mark,
work the loop into the terminal belt clamp. A 1/2 inch deep set socket can be used to assist in pushing
the belt into place. When the flat belt loop is about half way into the terminal clamp, push the pin into
the flat belt loop.
30 Continue to work the flat belt loop and pin into the terminal clamp until the side of the flat belt is resting
next to the clamp screw. Ensure the pin is centered within the terminal clamp.
FIGURE 86: FLAT BELT TERMINAL PIN
31 Install the second 1/4-20X1 replacement screw and shim that secure the flat belt to the terminal clamp.
Do not fully tighten at this time.
Outside Flat Belt Alignment
32 The flat belts ends will now need to be adjusted to their final position before the flat belt clamp screws
can be fully tightened. Gently press down on the stairarm pedal that corresponds to the replacement
belt.
33 Gradually increase downward pressure on the stairarm pedal while closely monitoring the flat belt ends
for movement through the belt clamps.
34 Monitor the movement of the belt through the flat belt clamps until one or both ends of the flat belt has
one belt segment extending beyond the flat belt clamp.