Precor AB-103, Assembly Manual

Page: 11 / 48

AB-103 Assembly Guide
page 11
Assemble the Unit
1. Attach the Cross Brace to the Base Supports with
two Backing Plates using
four 5-inch buttonhead screws (A)
eight
¹⁄₂
-inch curved washers (B)
four ½-inch locknuts (C)
Wrench tighten using a ¾-inch open-end wrench.
2. Attach the Side Supports to the Base Supports
using
four ¾-inch buttonhead screws (D)
four ½-inch split washers (E)
Loosely tighten the fasteners so the Side Supports
are stable, but adjustments can be made when
installing the Center Support.
Note: Make sure the Side Supports are positioned
as shown in the illustration.
Assemble the Unit
Base Supports
Side Supports
Cross Brace
4 - ¾” buttonhead screws
4 - split washers
2 - Backing plates
4 - 5” buttonhead screws
8 - curved washers
4 - locknuts
Backing Plate
Make sure the Side Sup-
ports are positioned as
shown here.