Model PD6000 Analog Input Process Meter Instruction Manual
Making Changes to a Password Protected Meter
If the meter is password protected, the meter will display the message
Locd
(
Locked
) when the Menu button is pressed. Press the Enter button
while the message is being displayed and enter the correct password to
gain access to the menu. After exiting the programming mode, the me-
ter returns to its password protected condition.
Disabling Password Protection
To disable the password protection, access the
Password
menu and
enter the correct password twice, as shown below. The meter is now
unprotected until a new password is entered.
Locd
0
00000
Locd
6
00000
Locd
unLoc
Locd
reset
20.000
mA
Run Mode
Pass
Enter
Password
unLoc
Pass 1
If the correct six-digit password is entered, the meter displays the mes-
sage
unLoc
(
unlocked
) and the protection is disabled until a new pass-
word is programmed.
If the password entered is incorrect, the meter displays the message
Locd
(Locked) for about two seconds, and then it returns to Run Mode.
To try again, press Enter while the
Locked
message is displayed.
Did you forget the password?
The password may be disabled by entering a master
password. If you are authorized to make changes, enter
the master password 508655 to unlock the meter.
59
