SuperNova PD500 PID Process & Temperature Controllers
Instruction Manual
18
Connections
All connections are made to non-removable
screw terminal connectors located at the rear of
the controller.
The mini-USB connector is located at the front of
the PD520/PD530 and at the top of the PD510.
•
Use copper wire with 60°C or 60/75°C insulation
for all line voltage connections. Observe all safety
regulations. Electrical wiring should be performed
in accordance with all applicable national, state,
and local codes to prevent damage to the
controller and ensure personnel safety.
•
Use spade or ring terminals to secure wires.
Figure 5. Recommended Terminal Connectors
Connectors Labeling
The connector labelling diagraph marked on the
controller shows the location of all connectors
available with requested configuration.
All options are shown in the diagrams below, though
only installed options will appear on a controller.
Figure 6. PD510 Connector Diagram
Figure 7. PD520 & PD530 Connector Diagram