P
RO
V
U
™ PD6310-WM NTEP Certified Pulse Input Batch Controller
Instruction Manual
22
Basic Setup &
Programming
There is
no need to recalibrate
the controller
when first received from the factory.
The controller is
factory calibrated
prior to
shipment for frequency in Hz (pulses/sec) with
calibration equipment that is certified to NIST
standards.
Overview
Setup and programming is done using MeterView Pro
or through the front panel buttons.
Jumper J4 located inside the controller, behind the
input signal connector, is used to select the excitation
voltage (24 V [
Default Setting
], 10 V or 5 V) which is
supplied to the P+ and P- wiring terminals.
After power and input signal connections have been
completed and verified, apply power to the controller.
Front Panel Buttons and Status
LED Indicators
Button
Symbol
Description
LED
Status
Menu
1-8
Relay 1
– 8
indicators
START
(Right
arrow/F1)
R
Rate
indicator
BATCH
(Up
arrow/F2)
T
Batch Total
indicator
STOP
(Enter/F3)
G T
Grand Total
indicator
Note:
F4 is a digital input. Alarms
5-8 enabled when relay
expansion module is
installed.
▲
Total
overflow
indicator
Note:
LEDs for relays in manual
mode flash with the “M”
LED every 10 seconds.
“M” flashing by itself
indicates Aout
– manual
control is used.
M
Manual
control relays
&/or analog
output
Programming
•
Press the Menu button to enter or exit the
Programming Mode at any time.
•
Press the Right arrow button to move to the next
digit during digit or decimal point programming.
•
Press or hold the Up arrow button to scroll
through the menus, decimal point or press or
hold to increment the value of a digit.
•
Press the Enter button to access a menu or to
accept a setting.
•
Press and hold the Menu button for three
seconds to access the advanced features of the
controller.
