Faults
57
Do not perform any repairs on the tacker.
Make sure that all faults on the tacker have been corrected by
PREBENA Service.
Fault overview
Potential faults and the necessary corrective measures are listed in
the following overview.
Symptom
Potential cause
Remedy
Tacker is losing air.
Attachment screws are
loose.
Tighten attachment
screws.
A seal is defective.
Inform customer service
(see page
Fehler!
Textmarke nicht
definiert.
).
Fasteners are not driven
in fully.
Operating pressure is
too low.
Increase operating
pressure (see page 32).
The driver tip on the
tacker is worn down.
Inform customer service
(see page
Fehler!
Textmarke nicht
definiert.
).
Summary of Contents for 1A-AZ16BNH
Page 28: ...Eintreibger t bedienen 4C WZ38BNH 4C WZ38BNH400 28...
Page 47: ...Nach dem Betrieb 47 Schlie en Sie das Magazin siehe Seite 29...
Page 117: ...After operation 47 Close the magazine see page 28...
Page 137: ...Technical data 67 Noise characteristics per DIN 12549 1999 LWA 1s 95 3 dB LpA 1s 82 3 dB...
