AeroSwitch User’s Guide
7
Setting up Devices not listed above
1.
Open the Bluetooth settings on your device.
2.
Ensure the AeroSwitch is turned off.
3.
Set the rotary dial to the keyboard mode you want to use and turn the AeroSwitch on.
4.
Press the AeroSwitch pairing button.
The blue LED must be blinking.
Note:
This makes the AeroSwitch discoverable to your device.
5.
On the device, select the AeroSwitch In the device’s Bluetooth settings.
6.
If you are prompted for a code, enter
000000
.
7.
Tap
Pair
.
8.
To connect a second AeroSwitch, set the rotary dial to a different keyboard mode and repeat the steps above.
Note:
To set up switch scanning, refer to the documentation available for your device.
Waking the AeroSwitch
(applies to keyboard mode only)
After 30 minutes of no activations, AeroSwitch will go to sleep. Press the switch to wake it up. It will take a few
seconds to wake. Your first switch press might be missed and need to be repeated.
Using the AeroSwitch with Wired Switches
You can use single or dual wired switches with the AeroSwitch for 2-switch scanning.
First, plug any combination of single and dual switches into switch jacks A and B. Then set up the AeroSwitch as
described under the appropriate “Setting up” section above.
Disconnecting and/or Unpairing the AeroSwitch and Device
If you want to use the AeroSwitch with a different device, unpair it from the original device.
Accent Device with NuVoice in Broadcast Mode
1.
In NuVoice, go to the Toolbox and select
Access Method Menu
.
2.
Select
Disconnect ALL AeroSwitch
.
3.
Select
OK
twice.
Accent Device with Empower in Broadcast Mode
1.
In Empower, select
Menu
>
Toolbox
>
System Settings
>
Devices & Connections
.
2.
Select the
Switches
tab.
3.
Select the Connect Switch
Disconnect all
button. “Do you want to disconnect all of the switches?” will appear.
4.
Select
Okay
. “Unpairing Switches” will appear. When the message disappears, the switch has been disconnected
5.
Select
Close
.
Accent Device with NuVoice or Empower in Keyboard Mode
1.
On the device, open the Bluetooth Settings in Windows.
2.
Select the AeroSwitch from the list of devices connected.
3.
Select
Remove Device
and click
Yes
.
NovaChat or ChatFusion Device
If you connected the AeroSwitch in broadcast mode, you do not need to disconnect it from the device.
If you connected the switch in keyboard mode, disconnect it by selecting
Menu
>
Settings
>
System
>
Bluetooth
Settings
>
Connect to Switch
and then selecting
AeroSwitch
.
Devices not listed above
Open the Bluetooth settings on your device and disconnect/unpair according to your operating system
documentation.
