INSTRUCTION SHEET
71184 Drill Press Table 16" x 24" with
hold down clamps
21-0514
QUESTION...
1•847•780•6120
WARNING
This product is to be used with a drill press. Before using this
product, always read, understand and follow the instructions
and safety warnings in the owner’s manual for the drill press. If
you do not have the owner’s manual, obtain one from the tool’s
manufacturer before using it with this product.
You must be familiar with the use of any tool or accessory used
with this drill press table/fence system. The supplier cannot be
held responsible for any accident, injury or damage incurred
while using this drill press table/fence system with any tool.
It is the responsibility of the purchaser of this product to ensure
that any person using this product reads and complies with all
instructions and safety precautions outlined in this manual and
the operating manual of the tool being used prior to use.
CAUTION
Do not modify or use this drill press table/fence system for any
application other than that for which it was designed.
WARNING
• To avoid serious injury, turn off and unplug the drill press
before attaching, adjusting or changing accessories.
CAUTION
Think safety! Safety is a combination of operator common sense
and alertness at all times when tool is being used.
WARNING
Do not use the drill press table/fence system until it is completely
assembled and you have read and understood this entire
operating manual and the operating manual of the tool being
used with this drill press table/fence system.
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE
PACKAGING CONTENTS
ITEM DESCRIPTION
QTY
A
16" x 24" Table with mounted double wide
engraved T-Tracks
1
B
36" Double Wide Engraved Fence
1
ITEM DESCRIPTION
QTY
C
Flip Stops
2
D
1/4"-20 x 1" T-Bolts
4
E
1/4"-20 x 5/8" Round Knobs (metal)
2
F
5-1/2" Hold Down Clamps
2
G
5/16"-18 x 3-1/2" T-Bolts
2
H
5/16" Washers
6
I
5/16"-18 Five Star Knobs
2
J
Fence Mounting Blocks
2
K
1/4"-20 x 1-1/2" T-Bolts
2
L
1/4"-20 x 3/4" Round Knobs (plastic)
4
M
Table Insert
1
N
#6 x 1/2" Adjustment Screws (Insert)
4
O
1" Fender Washers
4
P
#10 x 1-1/4" Pan Head Screws
4
Q
5/16"-18 x 1" Hex Bolts
4
R
Oval Nuts
4
Figure 1
A
B
C
D E K D
L
G
I
F
H
J
M
N
P
O
H
Q
R
ASSEMBLY
Assemble to Drill Press
Refer to Figure 2–5
Installation to Through Slotted Drill Press Tables
1. Place the POWERTEC table onto the drill press table with
the short side of insert opening to the column as shown.
2. Insert a 3/8" bit into the drill chuck and feed it through the
calibration hole in the table insert. Square the table and lock
the spindle.
Figure 2
Table Insert
Table
Column
Calibration Hole
