POWXG30412
EN
Copyright © 2020 VARO
P a g e
|
13
www.varo.com
14 STORAGE
WARNING: Failure to follow these steps may cause varnish to form in the
carburettor and lead to difficult starting or permanent damage after storage.
▪
Clean outside surface of unit.
▪
Drain fuel from the fuel tank.
▪
After fuel is drained, start engine.
▪
Run engine at idle until unit stops. This will purge the carburettor of fuel.
▪
Allow engine to cool (approx. 5 minutes).
▪
Using a sparking plug wrench, remove the sparking plug.
▪
Pour 1 teaspoon of clean 2-cycle oil into the combustion chamber. Pull starter rope slowly
several times to coat internal components. Replace sparking plug.
▪
Store unit in a cool, dry place away from any source of ignition such as an oil burner,
water heater, etc.
▪
Put the sleeve on when not in use or in transportation.
15 REMOVING A UNIT FROM STORAGE
▪
Remove sparking plug.
▪
Pull starter rope briskly to clear excess oil from combustion chamber.
▪
Clean and gap sparking plug or install a new sparking plug with proper gap.
▪
Prepare unit for operation.
▪
Fill fuel tank with proper fuel / oil mixture. See Fuel and Lubrication Section.
