POWX221
EN
Copyright © 2017 VARO
P a g e
|
6
www.varo.com
10. Always lock the different degree set-ups before you start processing.
11. Only buy suitable saw blades with a number of revolutions of at least 6000 revolutions
per minute.
12. Only use the correct saw blade. Too small or too big saw blades are extremely
dangerous.
13. Regularly inspect the saw blade for any faults. Replace the saw blade if necessary.
14. Grease the new saw blade and clean the flanges before you assemble the new blade.
Then assemble the blade in the correct direction and pull the flanges firmly using the
central bolt.
15. Only use original flanges. All other types are not suitable.
16. Never work without the protective cap of the saw blade.
17. The moving part of the protective cap must also remain assembled.
18. Never grease the saw blade while it is rotating.
19. Always keep your hands removed from the track of the saw blades.
20. Never pick up the workpiece by grasping with your hands along or behind the saw blade.
21. Ensure that the workpiece never touches the saw blade before the machine has been
switched on.
22. Never process metal or stone sorts with this machine.
23. Use support aids in order to support long workpieces.
24. Never use the machine in a dangerous environment, where inflammable gases or fluids
are present.
25. Never leave the machine unattended without first disconnecting it from the mains voltage.
26. If you hear abnormal noises, try to trace them or take the machine to a recognized fitter,
or repair company.
27. If a part is broken or damaged, replace it or repair it immediately.
28. Never stand in the track of the saw blade but stand to the left or the right of the saw
bench.
29. Your hands must likewise be placed next to the track of the saw blade.
30. Always use a wooden pole instead of your hands to push the wood through the saw.
31. Always place the wood at the front of the saw bench and then push it further back.
32. For mitring only the adjustable guide must be used and the fence must be removed.
33. Never use the fence as a linear measure for cutting off beams.
34. If the saw blade is blocked: first switch off the machine before you attend to the fault.
35. Avoid workpieces hitting back in your direction by taking the following measures:
Always use sharp saw blades.
Do not saw too small workpieces.
Never release the workpiece before it has been completely pushed through the saw.
Always adjust the guide parallel to the saw blade.
Never remove the saw protection.
36. Before you continue sawing, ensure that you are standing firmly and that your hands are
in the required position.
37. Never use thinners to clean the machine. Only use a damp cloth for cleaning.
38. Do not use saw blades which are damaged or deformed.
39. Replace table insert when worn.
40. Use only saw blades recommended by the manufacturer.
41. Take care that the selection of the saw blade depends on the material to be cut.
42. Connect circular saws to a dust-collecting device when sawing.
43. Use and correct adjustment of the riving knife.
44. Use and correct adjustment of the upper saw blade quard.
45. Take care when slotting.
6.1
Before use, remove the transport protection:
Disassemble the bottom plate by loosening the 4 screws.
Remove the transport protection below motor.
