POWX07582
EN
Copyright © 2017 VARO
P a g e
|
14
www.varo.com
Before starting to work, check that the following items are in a proper condition.
Riving knife (2)
Safety saw blade guard (14)
Saw blade guard (3)
Push block
Wear protective clothing and apply the necessary protective measures:
Dust exhauster
Ear protection
Safety goggles
Stand in the correct position for operating the machine
At the front of the saw
In front of the saw
At the left side of the sawing line
If two persons are working at the same time, then the other person must stand at a
sufficient distance from the saw.
Use following accessories, if required by the type of work you are doing:
Workpiece support for long workpieces, which would otherwise fall off the table at the end
of the sawing process.
Dust collector
Do not try to stop the turning of the saw blade, by pressing the workpiece against the side
of the saw blade. A risk of injuries can occur, if the saw blade is blocked.
10.2.6
Sawing
HAZARD! Always use a push block, if the distance D of the workpiece is
less than 120 mm (Fig. 4).
The front edge of the saw blade guard must rest on the workpiece.
If necessary, install the mitre and width guide, and make sure that the locking screw points
in the operator's direction.
Set the mitre and width guide to the desired sawing width. Check on both scales of the
upper saw blade that the mitre and width guide has been set parallel to the saw blade.
Start the saw blade by pushing the green switch (7) into the “ON” position.
Push the workpiece slowly towards the back and saw it in one single and flowing
movement.
If further sawing is not immediately required, then turn the machine off by pushing the red
swit
ch (7) into the “OFF” position.
11 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug.
11.1
Cleaning
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
Regularly clean the machine housing with a soft cloth, preferably after each use.
Keep the ventilation slots free from dust and dirt.
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
