Powerplus POWX07582, Manual

Page: 13 / 20

POWX07582
EN
Copyright © 2017 VARO
P a g e | 13
www.varo.com

Push on the upper half of the ON/OFF switch and push on the safety lock.

Lower the saw head carefully and completely downwards, while firmly holding onto the
handgrip. You should only apply minimum pressure while sawing, so as to prevent the
motor from slowing down.

Saw the workpiece in one single movement.

Carefully let the saw head return to its topmost starting position.

If further sawing works do not have to be carried out immediately, switch the saw OFF.
10.2 Table saw mode
10.2.1 Safety instructions for the upper saw blade guard
The upper saw blade guard (3) protects against accidental contact with the saw blade and
prevents wood splinters from flying about.
Make sure that the upper saw blade guard is always installed while working.
10.2.2 Riving knife

The riving knife (2) prevents that a workpiece is grasped by the rising teeth of the saw
blade and is thrown in the direction of the operator.

Always make sure that the riving knife is installed while working with the saw.
10.2.3 Lower saw blade guard

The lower saw blade guard (14) is designed to provide protection against accidental
contact with the saw blade.

The safety saw blade guard must always be installed, while the machine is in operation.
10.2.4 Push block

A push block (24) serves as an extension of the hand and protects against accidental
contact with the saw blade.

Always use a push block, when the interval between the saw blade and the mitre and
width guide is less than 120 mm.

Use the push block at an angle of 20° to 30° in relation to the surface of the saw table.

Replace the push block when damaged.
10.2.5 Installation
HAZARD!
Before starting with the installation of the machine:

Switch the
machine “OFF

Remove the plug from the socket

Wait until at the machine has come to a complete standstill

Leave the saw head in a raised position.

Set the mitre saw in the 0° position and tighten up the locking screw.

You must position the lower saw blade guard (14) correctly and you must make sure that
switch B (29) is activated.

Lower the saw head and lock it in position.

Remove the mitre and width guide (4) from the saw blade guard (3).
HAZARD!