POWEG5011
EN
Copyright © 2019 VARO
P a g e
|
8
www.varo.com
▪
Do not allow processed material to build up in the discharge zone; this may prevent proper
discharge and can result kickback of material through the feed intake opening.
▪
If the machine becomes clogged, shut of the power source and disconnect the spark plug
wire from the spark plug (electric unit disconnect from supply) before clearing debris. Keep
the power source clear of debris and other accumulations to prevent damage to the power
source or possible fire. Remember that operating the starting mechanism on engine
powered machines will still cause the cutting means to move.
▪
Keep all guards and deflectors in place and in good working condition.
▪
Do not tamper with the power source governor settings; the governor controls the safe
maximum operating speed and protects the power source and all moving parts from
damage caused by over speed. Seek authorized service if a problem exists.
▪
Do not transport this machine while the power source is running.
▪
Shut off the power source and disconnect the spark plug lead (electric unit disconnect
from supply) whenever you leave the work area.
▪
Do not tilt the machine while the power source is running.
6.3
Maintenance and storage
▪
When the machine is stopped for servicing, inspection, or storage, or to change an
accessory, shut off the power source, disconnect the spark plug wire from the spark plug
(electric unit disconnect from supply), make sure that all moving parts have come to a
complete stop and, where a key is fitted remove. Allow the machine to cool before making
any inspections, adjustments, etc.
▪
Store the machine where fuel vapour will not reach an open flame or spark. For extended
storage periods, run the unit dry of fuel. Allow the machine to cool before storing.
▪
When servicing the cutting means be aware that, even though the power source will not
start due to the interlock feature of the guard, the cutting means can still be moved by a
manual starting mechanism.
6.4
Additional safety instructions for units with bagging attachments
▪
Shut-off the power unit before attaching or removing the bag.
7
ASSEMBLY INSTRUCTIONS
Warning! You may need assistance when lifting the machine out of the box
and assembling.
Open the package and remove the machine from package;
Pull out the collect bag and take out the main part of the machine and all accessories.
7.1
Assembly of the shredder
▪
Turn the shredder upside down.
▪
Insert the wheel axle (10) through the pre-drilled holes in the foot (Fig. 1).
▪
Select the support A and B which are identified by the letter stamped on the actual
support.
▪
Insert the foot (11) into the body.
▪
Mount the wheel in the same order illustrated in fig 2 ensure the nut is not too tight.
▪
Tighten the hand screw (2). The hand screw has a safety switch please ensure the knob is
tightened or the motor will not activate.
NOTE: It is dangerous to use the machine without the hopper (1).
