POWDP8060
EN
Copyright © 2020 VARO
P a g e
|
6
www.varo.com
6.2
Chargers
▪
Never attempt to charge non-rechargeable batteries.
▪
Have defective cords replaced immediately.
▪
Do not expose to water.
▪
Do not open the charger.
▪
Do not probe the charger.
▪
The charger is intended for indoor use only.
7 ADDITIONAL SAFETY INSTRUCTIONS FOR RADIO
7.1
Li-ion battery
Advantages of Li-ion batteries :
▪
Li-ion batteries have a higher capacity/weight ratio (more power for less heavy, more
compact, battery)
▪
No memory effect (capacity loss after several charge/discharge cycles) like other type
batteries. (Ni-Cd, Ni-MeH ..).
▪
Limited self discharge. (also see chapter : Storage)
7.2
Charging tips
▪
Never over-discharge a battery by using the radio even after radio performance has
decreased. When radio performance begins to diminish stop the radio and recharge the
battery for optimal performance.
▪
Allow the radio to cool down after use; avoid placing the charger and radio in a warm
environment.
7.3
FCC safety for radio
This device complies with part 15 of the FCC rules. Operation is subject to the condition that
this device does not cause harmful interference and must accept any interference received,
including interference that may cause undesired operation.
WARNING: Changes or modification to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipement.
NOTE: This equipment has been tested and found to comply with the limits
for a class B digital device, purusant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and radiates radio frequency energy
and, if not installed and used in accrodance with the instruction, may cause harmful
interference to radio communciaton.
However, there is no guarantee that interference will not occur in a particular installion. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
▪
Reorient or relocate the receiving antenna.
▪
Increase the separation between the equipment and receiver.
▪
Connect the equipment into an outlet on a circuit different from that to which the receiver
connected.
▪
Consult the dealer or an experienced radio/TV technician for help.
