POWDP8031
EN
Copyright © 2020 VARO
P a g e
|
5
www.varo.com
5.1 Batteries
▪
Never attempt to open for any reason.
▪
Do not store in locations where the temperature may exceed 40 °C.
▪
Charge only at ambient temperatures between 4 °C and 40 °C.
▪
When disposing of batteries, follow the instruction
s given in the section “Protecting
the environment”.
▪
Do not cause short circuits. If connection is made between the positive (+) and
negative (-) terminal directly or via accidental contact with metallic objects, the battery
is short circuited and an intense current will flow causing heat generation which may
lead to casing rupture or fire.
▪
Do not heat. If batteries are heated to above 100 °C, sealing and insulating
separators and other polymer components may be damaged resulting in electrolyte
leakage and/or internal short circuiting leading to heat generation causing rupture or
file. Moreover do not dispose of the batteries in fire, explosion and/or intense burning
may result.
▪
Under extreme conditions, battery leakage may occur. When you notice liquid on the
battery, proceed as follows:
−
Carefully wipe the liquid off using a cloth. Avoid skin contact.
−
In case of skin or eye contact, follow the instructions below:
✓
Immediately rinse with water. Neutralize with a mild acid such as lemon juice
or vinegar.
✓
In case of eye contact, rinse abundantly with clean water for at least 10
minutes. Consult a physician.
Fire hazard! Avoid short-circuiting the contacts of a detached battery. Do
not incinerate the battery.
5.2 Chargers
▪
Never attempt to charge non-rechargeable batteries.
▪
Have defective cords replaced immediately.
▪
Do not expose to water.
▪
Do not open the charger.
▪
Do not probe the charger.
▪
The charger is intended for indoor use only.
6
SAFETY WARNING FOR WORK-LIGHT
▪
This is not a toy; children are not permitted to use this led work light. This item is a
DIY product, all electronic parts are fixed already, any intention of opening the work-
light or changing the work-
light’s design is prohibitive.
▪
Do not attempt to replace or change the diode lights! If the protective glass is cracked
or broken, it must be replaced before the work light can be used again.
7
OPERATION
7.1 Charging the battery pack
The battery pack for this tool is supplied in a low charge condition to prevent possible
problems, therefore, you have to charge the battery before first use.
